VT220 Programmer Reference Manual| Chapter 4 | Contents |
| Sequence | State | Stored in NVR | |
|---|---|---|---|
| * Applies only to later restore cursor commands (DECRC). | |||
| Text cursor | On | Yes, NVR value ignored. | |
| Insert/replace | Replace | No | |
| Origin mode | Absolute | No | |
| Auto wrap | Off | Yes, NVR value ignored. | |
| Keyboard action | Unlocked | No | |
| Keypad dode | Numeric | No | |
| Cursor key mode | Normal | No | |
| Top margin | 1 | No | |
| Bottom margin | 24 | No | |
| Multinational/ national | Multinational | Yes, NVR value ignored. | |
NOTE: The current mode (national or multinational) is not affected by the "Reset Terminal" field in set-up. |
|||
| Character Sets | VT200 defaults when in VT200 mode. VT100 defaults (via set-up only) when in VT52 or VT100 mode. |
No | |
| G0, G1, G2, G3 GL, GR |
|||
| Video character attributes | Normal | No | |
| Selective erase attributes | Normal (erasable by DECSEL/DECSED) |
No | |
| Save Cursor State* | No | ||
| Cursor position | Home | ||
| Character sets | VT100 or VT200 defaults (as appropriate) | ||
| Selective erase attribute bit write state | Off | ||
| SGR write state | Normal | ||
| Origin mode | Normal (reset) | ||
| Character shift (G0 to GL, G2 to GR, no shifts) | Power-up defaults | ||