Windows 95 Driver Addendum
RoamAbout/FH ISA and PC Card Products
=====================================

On the enclosed diskette, you will find the RoamAbout/FH Windows 95 driver
for the ISA Adapter and the PC Card Adapter.  This addendum is intended to
help you install the driver.

This driver is compatible with any ISA-bus computer and any computer 
with a PC Card (PCMCIA) socket that runs Windows 95.


Installation Instructions
=========================

The first time you insert the RoamAbout/FH PC Card, Windows 95 will prompt 
you for an OEM driver diskette.  Insert the driver diskette and follow the 
on-screen instructions.

When installing the RoamAbout/FH ISA driver, or if you choose to not install 
the RoamAbout/FH driver the first time you were prompted, follow these 
instructions:

From the Start / Settings / Control Panel / Network icon, click the Add 
button.  Then highlight Adapter and click on the Add button again. Next pick
the Have Disk box.  

Insert the driver diskette when prompted.  Select RoamAbout/FH ISA Adapter 
or RoamAbout/FH PC Card Adapter.  Click OK.  The driver will be added and 
you can then configure the network and the RoamAbout/FH settings.  

To change the RoamAbout/FH settings, highlight the adapter name and pick 
Properties. Choose the property you wish to change, and you will be able 
to enter a new value.



Installing the Windows 95 and NT Site Survey and Configuration Tool.
====================================================================

From the Start button, choose Run and type in A:\SETUP.  (If you are using 
a different drive designator replace the A: with the correct drive letter.)  
Follow the on-screen prompts to complete the installation.

A new Program Group will be added to your Programs, called "RoamAbout 
Utilities".  A Status Monitor will also be added to your "StartUp" group, 
that will automatically get executed when every you start your computer.

To start the utility, there will be an icon in on the "Start" bar or you can
select the "RoamAbout Site Survey & Configuration Tool" from the Program group
under "RoamAbout Utilities".

The usage of this utility is self explanatory or you can use the HELP utility
within the tool to help you further.



Troubleshooting
===============
After you install the RoamAbout/FH driver, you are prompted to reboot the 
your computer.  As the driver loads upon bootup, you should see the green 
LED flicker briefly in the presence of other RoamAbout/FH equipment.  

If there are no LEDs and you are unable to access the rest of your network, 
the driver may have loaded improperly.  You can verify this by going to 
Control Panel and choosing the System icon.  Under the Device Manager tab, 
double-click the Network Adapter line.  If the RoamAbout/FH driver is listed
with an exclamation point (!) or X next to it, the driver did not load.  
This may be due to a resource conflict, i.e. memory address, I/O port 
address or IRQ.

If the driver loads successfully but you still cannot access the network, 
verify the Domain, Station Type and Security ID settings match those of 
the other unit you are trying to communicate with.  These settings are 
described in detail in the RoamAbout/FH User’s Guide.