DIGITAL


           AV-PC9NE-TE



           Read This Before Installing Your IEEE488 Bus Converter (IEZ11)


           IEZ11 Microcode

           The IEZ11 software Version 2.1 runs only on a SCSI488/D with mi-
           crocode revision 4.5 or higher. The IEZ11 software does not work
           with SCSI488/D prototypes. All SCSI488/Ds ordered through normal
           channels have the correct version of the microcode installed. You
           can determine the
           microcode revision from the Installation Verification Procedure
           (IVP). To run the IVP enter the following command line:

              $ RUN SYS$SYSTEM:IEZ11$IVP

           Microcode revision 4.6 requires IEZ11 software Version 2.0-B or
           higher.

           Product Installation

           Before installing your hardware and software, first read the
           IEZ11 Hardware Installation Guide, the IEZ11 Software Installa-
           tion Guide, and the release notes, supplied on the software media.
           Pay particular attention to configuration and termination rules.

           License Installation

           Before installing your IEZ11 software Version 2.1, you must first
           install the license. You can install the license at the DCL level
           by entering the following command line:

              $ @SYS$UPDATE:VMSLICENSE

           Servicing the IEZ11

           Your IEZ11 contains no internal user-selectable or user-serviceable
           parts. The supply voltage rating is set at the factory. All re-
           pairs and modifications must be performed by qualified personnel.




                              The DIGITAL logo is a trademark
                            of Digital Equipment Corporation.

                              © Digital Equipment Corporation.
                            March 1993. All Rights Reserved.