HP OpenVMS Systemsask the wizard |
The Question is: The following command is in my systartup_vms.com file: $ set logins/inter=128 Yet after a re-boot, the number of interactive logins reverts to 64. Why? And how does one set this parameter at startup? The Answer is : 5.2.7.15 Defining the Number of Interactive Users By default, when the system starts up, it limits to 64 the number of interactive users allowed to log in. To change the default value for the number of interactive users that you permit to log in to your system at one time, define the symbol STARTUP$INTERACTIVE_LOGINS to be the maximum number of users in SYSTARTUP_VMS.COM as follows: STARTUP$INTERACTIVE_LOGINS == n where n specifies the maximum number of interactive users that can log in at one time. Note The number of interactive users is determined by the value authorized by your VAX or Alpha computer license. Therefore, setting the number higher than the license limit has no effect. The maximum number of interactive users influences the service rating that the LAT software assigns to a service node. The LAT software uses a ratio of current users to maximum users in calculating a rating. An artificially high user limit results in a high service rating, indicating---erroneously---that the service node is more able to provide services. For information about LAT software, see Section 24.1. Example $ STARTUP$INTERACTIVE_LOGINS == 200
|