![]() |
![]() HP OpenVMS Systemsask the wizard |
![]() |
The Question is: I want the exact synatx to set up a dump file for a Decserver bugcheck dump. I have seen it before and I think its five lines in NCP defining the MAC addres of the decserver etc. I specify exact because I used it before but have long since forgotten and i t won't work unless it is the exact syntax. If you have a question then feel free to ask. regards gg The Answer is : Please contact Digital Network Products Group (www.dnpg.com) for assistance with and support for the DECserver series devices. Here is a typical DECserver node display from DECnet Phase IV: ncp> show node dsnode characteristics Node Volatile Characteristics as of ... Remote node = 1.12 (DSNODE) Service circuit = circuit Hardware address = 08-00-2B-0A-xx-xx Load file = SYS$COMMON:[DECSERVER]loadfile.SYS Dump file = SYS$COMMON:[DECSERVER]dumpfile.DMP Most DECserver installations will include software -- DSVCONFIG or the newer DSV$CONFIGURE, depending on the version, the latter is part of the DECserver Network Access Software -- that can perform the entire DECserver NCP-based network configuration for you. Again, DECserver hardware and software is owned by the DNPG folks.
|