Installation Notes for Compaq Fibre Channel Storage System Driver 
				on Solaris 8
            using Driver Update Diskette Labeled CPQfcs8.200

January 26, 2000

This file  contains information on  how to create and use CPQfcs8.200
DU (Driver Update)  Diskette for  installing the Compaq Fibre Channel
Host controller driver.

The following sections are described below:
1.  Contents of the DU
2.  Supported Hardware
3.  Installing the contents of the package

1.  Contents of the DU

The DU Diskette contains CPQfcs package, version 1.0.0 This version of
the CPQfcs  package  contains  Compaq  Fibre  Channel  Storage  System
driver, "cpqfcs", version 2.00


2.  Supported Hardware

This driver supports the following Compaq Fibre Channel Storage System
Host Controllers
*  Compaq Fibre Channel Storage System - EISA/PCI
*  Compaq 64-Bit/66-MHz Fibre Channel Storage System - PCI


3. Installing the Contents of the Package.

1. Loading the cpqfcs driver during Installation of Solaris 8.

1.  Boot  with   Device   Configuration  Assistant  Diskette  or  with
    Solaris 8 Software/WebStart CD.
2.  When  the  Configuration   Assistant screen is  displayed,  choose
    F4 option (F4_Driver Update)
3.  When the 'Install Supplemental Drivers' screen is displayed,remove
    the Configuration   Assistant  diskette  (if  it  is  used to Boot
    Solaris) and  insert  the  CPQfcs8.200 Driver Update diskette.
4.  Press F2_Continue.
5.  At this stage, the  cpqfcs driver is loaded from the diskette into
    the memory. 
6.  You can  also  add  other drivers  through  the  corresponding  DU
    diskettes at this stage.  Once all the required drivers are added,
    remove the DU diskette  from  the diskette  drive and reinsert the
    Configuration Assistant Diskette (if it is used to  Boot  Solaris)
    and press F4_Done.
7.  The Identified Device Drivers screen is displayed.
8.  Press  F2_Continue.  Continue  with  the  installation process  of
    Solaris  Operating System.
9.  At the end,  the  installation  program  prompts you to insert the
    CPQfcs8.200 DU diskette again.
10. Reinsert the CPQfcs8.200 DU diskette.
11. Press Enter to continue.
12. Following  is displayed while  successfully  installing the CPQfcs
    package.
     Installing package CPQfcs
     Compaq  Fibre Channel Storage System
     (i386) VERSION=1.0.0, REV=2000.01.26.02.00
     Copyright 2000, Compaq Computer Corporation. All Rights Reserved.
     Installation of <CPQfcs> was successful.
13. Remove the diskette from the diskette drive.
14. Follow  the  instructions  prompted  by  the  Solaris Installation
    Program.

2. Adding the driver to the already installed Solaris Operating System

1.  Become super user on your system.
2.  Check to see if Volume Management is running
# ps -ef | grep vold
3.  If Volume Management is running stop the same.
# /etc/init.d/volmgt stop
4.  Insert the CPQfcs8.200 DU diskette into the diskette drive.
5.  Mount  the CPQfcs8.200 DU diskette at the /mnt mount point:
# mount -F pcfs /dev/diskette0  /mnt
6.  Execute the install script on the diskette
# /mnt/DU/sol_28/i86pc/Tools/install.sh -i
7.  The following message gets displayed on successful installation.
    Installation of <CPQfcs> was successful.
8.  Unmount the diskette from the / directory:
# umount /mnt
9.  Remove the DU diskette from the diskette drive.
10. Reboot the system.
# reboot 
11. During bootup, give "b -r" as a boot option.