AdapterID 060FCh

AdapterName "AMS RS232CL or RS422/485-IO MC Adapter (Rev B)"

NumBytes  1

NamedItem

       Prompt "SERIAL PORTS are configured to:"


       choice "COM-2,3  IRQ-3,3"
               pos[0] = X001XXXXb
               io 2F8h-2FFh 3220h-3227h

       choice "COM-3,4  IRQ-3,3"
               pos[0] = X010XXXXb
               io 3220h-3227h 3228h-322Fh

       choice "COM-4,5  IRQ-3,3"
               pos[0] = X011XXXXb
               io 3228h-322Fh 4220h-4227h

       choice "COM-5,6  IRQ-3,3"
               pos[0] = X100XXXXb
               io 4220h-4227h 4228h-422Fh

       choice "COM-6,7  IRQ-3,NONE"
               pos[0] = X101XXXXb
               io 4228h-422Fh 5220h-5227h

       choice "COM-1,2  IRQ-3,NONE"
               pos[0] = X000XXXXb
               io 3F8-3FFh 2F8H-2FFh

       choice "Setup for DISABLE"
               pos[0] = X110XXXXb


Help
      " COM implies Serial Port.  Example:  COM-2,3...  If this choice is
        selected, the RS422/485 adapter card will be configured for COM port 2
        & 3.  The serial port addresses are as follows:  COM1=3F8h, COM2=2F8h,
        COM3=3220h, COM4=3228h, COM5=4220h, COM6=4228h, COM7=5220h, COM8=5228h.
        Press F5 for previous choice, F6 for next choice.  "



NamedItem

       Prompt "Serial Port #1 Interrupt"

       choice "IRQ-3"
               pos[1] = XXXXXX1Xb
               int 3

       choice "IRQ-4"
               pos[1] = XXXXXX0Xb
               int 4


Help
      " This option selects the interrupt level that will be used by the
        primary serial port on the RS422/485 board.
        Press F5 for previous choice, F6 for next choice. "


NamedItem

       Prompt "Serial Port #2 Interrupt"

       choice "IRQ-3"
               pos[1] = XXXXX1XXb
               int 3

       choice "IRQ-None"
               pos[1] = XXXXX0XXb

       choice "IRQ-Special"
               pos[1] = XXXXX0XXb


Help
      " This option selects the interrupt level that will be used by the
        secondary serial port on the RS422/485 board.  The choice IRQ-Special
        is a factory configured special interrupt level for this port that can
        be specified by the customer.  Press F5 for previous choice, F6 for
        next choice.  "



NamedItem

       Prompt "The AMS Adapter is presently:"

       choice "ENABLED"
               pos[0] = XXXXXXX1b

       choice "DISABLED"
               pos[0] = XXXXXXX0b


Help
    " When the RS422/485 MC adapter is ENABLED, both of its ports
        are active.  When it is DISABLED, both of its ports are inactive.  To
        change the selection use:  F5 = previous choice F6 = next.  "