This is an ULTRIX to OSF/1 migration question. On ULTRIX, I could put
arp -s commands in the /etc/rc.local file for my Ethernet IMLOGIX
screens. OSF/1 has scripts under /sbin/init.d which are called from the
various /etc/rc*.d files. Does anyone have an idea where the arp -s
lines should go? I need three entries to always be available on the arp
table and I do not know where under /etc/rc*.d I should put them. Unless
of course I make a script of my own, but then again, I am not sure which
would be the correct run level to call it from.
Thank you in advance.
================================================================================
Menelaos Nicholaos Karamichalis, M.S. | 510 South Kingshighway Boulevard
mnk_at_wuerl.wustl.edu | Electronic Radiology Laboratory(ERL)
Work # (314)-362-6965 | Mallinckrodt Institute Of Radiology
Home # (314)-361-0865 | St. Louis, Missouri 63110, USA
What, didn't we just go to work yesterday???
================================================================================
Received on Wed Jan 04 1995 - 17:23:43 NZDT