Hi, managers!
I just bought a dual scsi controller (turbochannel) for my 3000/300.
I plugged it in and configured it for fast scsi etc, I can also
see my devices when I'm in the boot monitor, but I havent been able
to make OSF recognize it (I'm running 2.0).
I've booted up genvmunix and tried the normal doconfig etc., but no luck,
the new kernel doesn't recognize the board. I also tried scanning the bus
with scu (I guess they are 1 and 2 as the builtin is 0), no luck. sizer -n
doesn't give me anything valuable either. And yes, vmunix was a link to
genvmunix while I was doing all this.
So: is there a bug in the recognition of this board? Accorging to the
docs it should be supported from 1.3 on. Or does the rev. C of this
board require a new driver. Or is it possible to add the stuff in the
config file by hand? Other suggestions?
Regards, Harald
Harald Lundberg <hl_at_tekla.fi>;Tekla Oy,Koronakatu 1,FIN-02210,ESPOO,FINLAND
tel +358-{0-8879449work,0-8039489fax,0-8026752,11-728013res,50-5578303mob)
Received on Tue Feb 07 1995 - 14:14:54 NZDT