This problem was my fault. I made the assumption that if it worked on V3.0, it
would work on V3.2, but that's not the case. The software vendor is shipping a
V3.2 version next month. So my solution was to move my system back to V3.0.
dan
original:
>Trying to install FASTech software on V3.2a, and part of the installation
>requires the use of sysconfig and sysconfigdb.
>
>The instructions say to copy srr.mth and srr.mod to /subsys, then run
>/sbin/sysconfigdb -f $CELLworks/etc/srr.stf -a srr.
>
>This seemed to work, because an entry shows up in /etc/sysconfigtab.
>
>But the next step dies. It says to run
>
>/sbin/sysconfig -c srr
>
>and here's what happens.
>
># sysconfig -c srr
>method failed to perform preconfiguration
>subsystem error: Not owner
>#
>
>I don't know much about the sysconfig stuff, but something seems to be
>configured wrong. I am stuck here, any advice?
>
>thanks,
>dan cambron
Received on Wed May 24 1995 - 13:11:42 NZST