Hi All,
I am trying to get a DECstation 3000/300 to talk to a EPROM burner via
the serial port. The EPROM burner is connected to the serial port via a
null-modem cable.
I have loaded up the UUCP subsets, and entered the following
configuration lines:
/usr/lib/uucp/Devices:
eburn tty00 - 9600 direct
/usr/lib/uucp/Systems:
eburn Any eburn 9600 - ""
/etc/inittab:
c0:3:respawn:/usr/lib/uucp/uugetty -r -t 30 tty00 9600 #UUCP
I have done a "kill -HUP 1"
I try to connect to the EPROM burner using cu, as follows:
# cu -d eburn
The answer I get is:
conn(eburn)
Device Type eburn wanted
ttylock tty00 succeeded
Attempting to open /dev/tty00
generic open failed, errno = 2
generic open timeout
getto ret -1
Call Failed: CAN'T ACCESS DEVICE
Connect failed: CAN'T ACCESS DEVICE
call cleanup(1)
call _mode(0)
#
Have I left out some obvious step??
TIA,
Garry
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
+ + +
+ Garry Optland + Even wise men were once babes. +
+ Pacific Power + +
+ NSW Australia +++++++++++++++++++++++++++++++++++++
+ [61] (2) 268 6160 +
+ <garry.optland_at_com.pacpower.nswgovpower.telememo.au> +
+ +
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Received on Fri Jun 09 1995 - 04:30:58 NZST