I have just received the 3.2B release kit. It did not include the ECU V1.8
Diskette that the release notes indicate is required, but DEC are dropping
one around tomorrow.
I am however finding the Installation Instructions less than crystal clear.
I *think* that what I need to do is update the Firmware and ECU and then do
an update install of 3.2B following the instructions in the "Installation
Guide Version 3.2" (ie. the same instructions as for updating from 3.0 to
3.2). Can anyone confirm or deny this procedure?
If it matters I have an AlphaServer 2100 4/275 currently running OSF/1 3.2.
(Yeh I know I should have upgraded to 3.2A, but it wasn't obvious that I
should look on the complementary products CD for this and I have 3.2B now
anyhow)
Thanks in advance to all who respond, I will post a summary to the list.
clare
--
Clare West, Rm 107, Ext 8266
clare_at_cs.auckland.ac.nz
Received on Wed Aug 09 1995 - 06:53:30 NZST