Subject: Booting OSF/3.2 - cam_logger errors.....
First, I'm upgrading a DEC 3000 to OSF/3.2. I have upgraded the
firmware
to version 6.0. I can boot off the CD. I get to the point of selecting
the type of installation (basic,advance,maintaince) and selecting the
disk and type of filesystem to use as the boot disk. All of this is
succesful. Then ...... Below is the output from the boot up. Has
anyone seen these problems or understand what is going on. Any help
would be great!!
Thanks,
Jim Hofmann
The Johns Hopkins University - GDB
Initializing the system disk ......
Working:`data`
cam_logger:CAM_ERROR packet
cam_logger:bus0 target3 lun0
sim_err_sm
Target went to message out phase
cam_logger:CAM_ERROR packet
cam_logger:bus0 target3 lun0
sim_err_sm
Target went to message out phase
cam_logger:CAM_ERROR packet
cam_logger:bus0 target3 lun0
sim_err_sm
Target went to message out phase
cam_logger:CAM_ERROR packet
cam_logger:bus0 target3 lun0
sim 94_intr
Illegal command
.
.
.
.
Parity error on status
.
.
.
.
Bus reset detected
.
.
.
.
Around and Around we go on these errors
Received on Tue Nov 28 1995 - 16:28:51 NZDT