Hello all,
I'm trying to add 4 rz28s to an empty SCSI bus. I have a dual port
Turbo Channel to SCSI card in tc0. It works fine. It can run 8 bit
SCSI fast or slow. I have recently bought a StorageWorks (BA350-KB)
box and 4 RZ28M-VW. I have connected it to the DEC Alpha 3000-700 w/
the appropriate cable, and the Jumpers and terminators on the Storage-
Works box are set correctly for a single bus config. In the firmware
mode (>>> prompt) I have run "t tc0 cnfg". This probes the SCSI buses
on the tc0. The drives don't show up at all in fast or slow modes.
I feel sure I have bought the wrong drives and/or StorageWorks box.
What I need to know now, if I did buy the wrong stuff, is how to make
it work (convertors or settings) or what I need to replace.
Thanks in advance. This is my second time querying this group and
you were very helpful last time.
Later,
Karl
kliebert_at_kgo.csc.com
Received on Thu Jun 20 1996 - 17:04:08 NZST