Hello, everyone;
A while back I posted about some problems I was having with my Dec AXPPci33
motherboard. I'm pleased to annouce that, after replacing the board on the
recommendation of a contact I made through this list, the problem went away.
I'm now happily on my way to configuring my machine. Right now, I have a
1.0 GB drive on the built-in SCSI adapter, but I want to add a DEC KZPSA
SCSI-2 PCI adapter card and a Seagate 32550W drive. I've got the card in,
and the drive connected. It's the only device on the second bus, assigned
SCSI ID 1. The drive is terminated, as is the KZPSA, with both supplying
termination power. The KZPSA factory defaults to ID 7. The problem is that,
on boot, the KZPSA shows up in "show config" from the SRM console, but neither
the drive or the adapter show up in "show dev".
I'm using: Digital UNIX 3.2d, 64 MB RAM, DEC AXPPCI33 motherboard,
a Conner CFP1080S 1.0 GB drive on the built-in NCR SCSI controller, an
S3-based number 9 video card, a DE500 10/100 adapter, and the KZPSA
SCSI-2 controller. I have the seagate drive connected with a 68 pin
M-M SCSI cable, one end in the KZPSA, the other in the drive.
Any suggestions would be greatly appreciated, and once again many thanks
to all those who helped me with my previous problem.
Erik
Erik Green
Technician,
Internet Connections
erik_at_ic.mankato.mn.us
Received on Fri Jun 28 1996 - 07:24:11 NZST