Hello DEC Unix managers,
I have acquired an Alphastation 500/333 system. This was a demo
system in a previous life, probably not running DEC UNIX. However, it was
supposedly reconfigured to run DEC UNIX. I received it with 3.2x
installed. I immediately installed DEC UNIX 4.0b. Now I'm wondering
whether I have a flakey scsi card. Below is what I am seeing every time I
boot up. Does the cam_logger messages mean anything? What does the NVRAM
parameters message mean? I could have had these messages when I first got
this system but I didn't notice. Otherwise, the scsi appears to be
functioning without problems.
Jun 25 15:42:11 uhhepp vmunix: isp0 at pci0 slot 9
Jun 25 15:42:11 uhhepp vmunix: isp0: QLOGIC ISP1020A
Jun 25 15:42:11 uhhepp vmunix: cam_logger: CAM_ERROR packet
Jun 25 15:42:11 uhhepp vmunix: cam_logger: bus 0
Jun 25 15:42:11 uhhepp vmunix: isp_probe
Jun 25 15:42:12 uhhepp vmunix: NVRAM parameters invalid, using driver Fast10
defaults
Jun 25 15:42:12 uhhepp vmunix: isp0: Firmware revision 2.10 (loaded by console)
Jun 25 15:42:12 uhhepp vmunix: scsi0 at isp0 slot 0
Jun 25 15:42:12 uhhepp vmunix: rz0 at scsi0 target 0 lun 0 (LID=0)
(DEC RZ28D (C) DEC 0008) (Wide16)
Jun 25 15:42:12 uhhepp vmunix: rz4 at scsi0 target 4 lun 0 (LID=1)
(DEC RRD45 (C) DEC 0436)
TIA,
Diane Ibaraki
University of Hawaii
High Energy Physics Group
<diane_at_uhheph.phys.hawaii.edu>
Received on Tue Jul 22 1997 - 20:06:07 NZST