adding SCSI cards

From: Jeff Besecker <besecker_at_pgenergy.com>
Date: Thu, 05 Nov 1998 06:39:38 -0500

I have recently added two additional SCSI cards: 1 KZPSA attached to a TL891, 1 KZPBA attached to RA7000. The
existing BA is attached to a HSZ50. My problem is when I boot genvmunix to perform the config, the HSZ50 devices
go from rz19-rz21 to rz35-rz37. When I do a "show dev" the device names that display are what was prior to the
new cards. Can I get DU to boot with the same device names? If not, is there a process that would allow me to
change the device names that ADVFS file sets are attached to once I rebuild the kernel?

Thanks

Jeff Besecker
PG Energy
email:besecker_at_pg-energy.com
717-829-8698
                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                       
Received on Thu Nov 05 1998 - 11:47:37 NZDT