Dear gurus.
I am having a bit of a problem trying to update from DU 4.0a to 4.0d on
an Alpha 255/233.
Following the instructions the following was done:
boot as single user
run /sbin/installupdate
in response to the message about deleting layered products (open3d and
MME)
run setld -i and setld -d.
Problem 1: I deleted everything related to MME and when I run setld -i I
don't find an entry but when I run installupdate MME appears on the list
again.
Problem 2: Due to lack of experience with this stuff I am very reluctant
to delete open3d related entries. Especially when I see entries in the
list related to the graphics card.
I am sure some one has gone through the same exercise so pls HELP
--
thanks in advance.
$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
Dr. Dimitrios Karamanlidis
$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
Received on Tue May 12 1998 - 22:02:42 NZST