Hello,
and thnx to everyone who responded! The closest answer for a rz26 came
from Chris Corcoran, although i still gor no information about the rz28.
Here it is:
* Front jumper block
| HDA
+------------------------- Pins Labeled 2 4 6 x 10 12 14 16 18 20
:::.:::::: 1 3 5 7 9 11 13 15 17 19
012^^^^^^^
|||||||
scsi||||||+---- Spindle Sync (Pin 20 GND Ret (or 2 4 6) - Pin 19
SPINDLE_SYNC))
id |||||+----- RESERVED
||||+------ AC Failure Notification (Pin 16 GND - Pin 17 AC_LOW)
|||+------- Spin Delay (Jumper Installed Spin up at pwer on)
||+-------- +5VDC OUT (Pin 11) HIGH (used with remote Busy and
Fault LOW)
|+--------- Spindle Sync Alternate (Pin 10 SPINDLE_SYNC))
| Remote Busy (Pin 9 BSY_OUT L)
+---------- Remote Fault (Pin 7 FLT_OUT L)
* Termination
/------ Install both shunt jumpers
| Drive will provide TERMPWR to SCSI bus and
| Termination Resistors if installed on drive
V
| :: |
| .----.----.---- | Termination Resistors
+||||================+
power scsi connector
conn
mit freundlichen Gruessen
Reimund Willig
------------------------------------------
e-mail: willig.reimund_at_gdr.de
tel: +49-5205-941747
fax: +49-5205-941725
** Schwer ist leicht was **
-----------------------------------------
Received on Fri May 07 1999 - 11:59:11 NZST