With a PWS 500au, we did a firmware upgrade to Rev: 6.9-7. Recently, a
power outage occured and we found that the machine did not automatically
reboot as it used to. So, I set the auto_action flag to RESTART. Now,
however, I can't get it to stop at the console prompt by pushing the reset
button on the front and we're sure that it worked that way in the past??
I tried setting auto_action to boot, but that seemed to change nothing.
What's the difference between restart and boot for the auto_action flag?
How can we restore the behavior of rebooting after a power-cycle, but
halting when the button is pushed?
Received on Tue Jul 13 1999 - 19:07:31 NZST