Hi All ,
I have just gotten a RA3000 with dual HSZ22 controllers .
To connect to a DS20 .
We upgraded the firmware for dual controllers to
(D110) using a PC with dual com ports , and
a hyperterminal (they make this a really fun job)
then configured the two controllers etc .
Everything looks fine from a PC .
The problem is that when I hook up via the host
using the network I cannot see the second controller .
The controller number 1 says they are set up active/active ?
On the back of the RA300 there is H0 and H1 scsi ports .
Do dual controllers need both ports connected to
two seperate cards . We only had one kzpba-cb
installed .
Thanking you ,
Gary Menna E-Mail g.menna_at_isu.usyd.edu.au
Information Technology Services Phone +61 2 9351-6360
University of Sydney (G05) Fax +61 2 9351-7711
*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*
* *
* When what is indestructible *
* Meets that which is irresistible . *
* The female always wins . *
* Monkey . *
*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*
Received on Fri Jul 23 1999 - 05:57:03 NZST