Sorry , a number of people asked me to clarify :
It is a pedestal .
When I connect SWCC using tcp/ip both the controllers
show up on the gui . When I click on either controller
1 or controller 2 only controller 1 shows up as active
and controller 2 is greyed out .
Even though it's greyed out , Controller 2 also does
not show the values I configured with the PC .
I go back to the PC/serial connection and it shows OK .
The User manual says , in fine print :
Each controller is configured to control one SCSI
host port . In order to utilize both controllers , you
must connect each SCSI port to a host bus
adapter . The two adapters can be in one host
system or in two different host systems .
Thanking you ,
Gary Menna E-Mail g.menna_at_isu.usyd.edu.au
Information Technology Services Phone +61 2 9351-6360
University of Sydney (G05) Fax +61 2 9351-7711
*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*
* *
* When what is indestructible *
* Meets that which is irresistible . *
* The female always wins . *
* Monkey . *
*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*
Received on Fri Jul 23 1999 - 06:28:39 NZST