Sorry for the delay in sending this summary. Hurricane Floyd
caused some anxious momements here and I am just now getting
around to sending this.
Thanks to all that replied. I got the answer in the first 10
minutes. I did not rebuild the kernel as I should have.
>>> boot -fi genvmunix
Then do a sizer command. Make the changes to the <MACHINENAME>
file in /sys/conf. Do doconfig -c MACHINE and install the new
kernel.
Original question:
-------------------------------------------------------------------
>I installed a kzpsa card into an Alpha 2000, running DU 4.0B
>and at the >>> prompt I could see the new card using the show
>dev command. A few days later I added a disk to the new scsi chain.
>When I did the show dev, the new disk did not show up. I powered
>off the system and tried again, but it would not show up. Anybody
>have any ideas what I should try?
--
Bob Morse
System Administrator
American Mathematical Society
Received on Mon Sep 20 1999 - 14:45:09 NZST