Thanks to all who replied. The short answer is that the console output
was set to serial in the factory. To fix this, hook up a terminal and use
">> set console graphics". I don't have a terminal on hand to try this,
but I anticipate it will work when I obtain one.
--Original Message-----
From: Ryan Grisso [mailto:rgrisso_at_cml.ME.Berkeley.EDU]
Sent: Tuesday, September 28, 1999 4:25 PM
To: tru64-unix-managers_at_ornl.gov
Subject: AlphaServer DS10
Hello,
While not a strictly Tru64 question, I plan to install Tru64, so it's
somewhat relevant.
I just purchased an AlphaServer DS10. I turn it on, it displays a brief
message about the video card and BIOS emulation, then it gives me a blue
screen. I cannot get the console prompt (>>). Is this a hardware
failure, or is there a key sequence that I need to use to get the console
prompt?
Received on Wed Sep 29 1999 - 00:50:13 NZST