Hello,
I have a DEC 2000, Model 300 AXP, ROM 2.2, Firmware version 370, that was
hanging on powerup. It did the device check, then printed the following
System power up OK
INIT-S-CPU
AUDIT_BOOT_STARTS
AUDIT_CHECKSUM_GOOD
AUDIT_LOAD_BEGINS
AUDIT_LOAD_DONE
an hung there.
I unplugged the hard disk to force a failure back to the >>> prompt, but is
there a key sequence to force the machine to the >>> prompt during or after
its power up cycle?
I don't have any hardware documentation for this beast, and I didn't see
anything in the System Administrator manual that came with our AlphaServer
4000.
Thanks, -- Bennet
<----- oOo ----->
Bennet Fauber
Social Science Data Service
University of California, Davis
Received on Mon Oct 25 1999 - 20:51:33 NZDT