Hello everybody,
I have problems installing a Decserver 90M. I never done this before and after
a long search in the Web I found the 90 Owner Manual.
The only good hint in the manual was the Pin Out for the 8 connectors. After
building a simple cable (rx/tx/gnd) cable I can see a little boot process when
connecting a terminal on port 1.
It say the firmware Version (4.1) and the hardware Adress the it attempts to
load the image MMENG2 from FLASHRAM and says that the load is completed.
After that nothing happens. I can press enter but there is no prompt (Local>
??). The connection LEDs 1to 4 and 5 to 8 are blinking 10 Minutes. When I put
my Terminal in a Port no LED shows me a connect.
I tried to give it a IP via arp -s IP HW but it don't worked. Is there any more
informations in the web about how to setup the server ?
Please help me :-))
Bye
Holger
Software & Logistik im Artland
Germany
Received on Thu Nov 11 1999 - 14:28:51 NZDT