FW: mchan0 not configured
> Hi all,
> I have had a problem with DUNIX V4.0d, Trucluster Production server V1.5
> and patch kits 3, 4 and 5. I am running TCR courses so need to install ASE
> remove and then install Production server.
>
> In short the memory channel card is seen but not configured at boot so
> cnx* and ase* fail. The error is "mchan0 not configured". I have spoken to
> a couple of people for whom this sounds familiar but no resolution is at
> hand.
>
> Problem
> Install DUNIX V4.0D and DUNIX patch kit 3. Install TCR v1.5 ASE, install
> TCR V1.5 patch kit 3. All fine.
> Delete TCR patches, delete TCR, Install TCR Production server V1.5, ran
> into dupatch "test argument" expected problem (not who -r however) when
> trying to install TCR V1.5 patch kit 3.
> Download patch kit 4, dupatch now works. Install all patches, including
> TCR
> and "mchan0 not configured" occurs.
>
> So try with patch kit 5, Install DUNIX V4.0d, Install DUNIX patch kit 5,
> install TCR ASE V1.5, install TCR V1.5 patches, all fine.
> Delete TCR ASE V1.5 and all DUNIX patches. Reinstall all patches. Install
> TCR Production server V1.5, install TCR patch kit 5, result "mchan0 not
> configured" Remove all patches and all is well.
>
> Other symptom: after booting with the patched kernel doconfig (not
> doconfig -c HOSTNAME) runs successfully but does not build support for
> mchan0 since it was not configured by the current running kernel. doconfig
> -c HOSTNAME fails however with a number of Mchan_* routines not found,
> since the current config files has an entry for mchan0 the build will try
> to link in the .mod for these routines and should find them. Not sure if
> this is the crux of the problem.
> Any help appreciated
> Regards Tom
Received on Wed Nov 17 1999 - 08:53:16 NZDT
This archive was generated by hypermail 2.4.0
: Wed Nov 08 2023 - 11:53:40 NZDT