Hi All,
I am trying to add a second QLogic SCSI card to a Personal Workstation
433/au running 4.0F.
>From the boot prompt, I can do a "show config" and I get the two SCSI
controllers:
Bus 01 Slot 04: ISP1040 Scsi controller
pkc0.7.0.1004.0 SCSI Bus ID 7
dkc0.0.0.1004.0 RZ2CC-KA
Bus 01 Slot 08: ISP1040 Scsi controller
pkd0.7.0.1008.0 SCSI Bus ID 7
dkd100.1.0.1008.0 RZ28M
mkd500.5.0.1008.0 TLZ07
I can do a "show dev" and all the devices on both SCSI controllers are
present.
However, when I boot up, I do not see the devices recognised. I
have tried a "doconfig -d" and a "doconfig -a" but still have no joy.
Is there some magic formula to make the system recognize the second SCSI
controller?
Regards,
Garry.
Received on Tue Dec 14 1999 - 10:16:22 NZDT