Hi gurus,
after installupdate from 4.0E to 4.0F and installation of C++-RTL and some
other sets we started the proengeneer-tool "proappmgr" (CAD-software) and
received following error message:
2435:/boots1_soft/ptc/appmgr2000i2/alpha_unix/obj/appmgr: /sbin/loader:
Error: Unresolved symbol in
/boots1_soft/ptc/appmgr2000i2/alpha_unix/obj/appmgr: __cxx_call_static_dtors
2435:/boots1_soft/ptc/appmgr2000i2/alpha_unix/obj/appmgr: /sbin/loader:
Fatal Error: this executable has unresolvable symbols
Note: This application ran fin under 4.0E!
Therefore we did a fresh install of 4.0F and the same subsets as above. Now
appmgr runs without problems.
Question: There should be no difference of upgrade to 4.0F anf new
installation of 4.0F??!
Hardware: ALPHA Workstation 600au
regards
Werner Rost
--------------------------------------------------
Werner Rost, Mannesmann-Boge GmbH
Abt: KIR
Tel: 0228/3825-420
Fax: 0228/3825-398
Email: werner.rost_at_boge.mannesmann.de
Friesdorfer Str. 175, 53175 Bonn - Bad Godesberg
---------------------------------------------------
-----------------------------------------------------------
This Mail has been checked for Viruses
Attention: Encrypted Mails can NOT be checked !
***
Diese Mail wurde auf Viren ueberprueft
Hinweis: Verschluesselte Mails koennen NICHT geprueft werden!
------------------------------------------------------------
Received on Mon Feb 26 2001 - 12:55:33 NZDT