Toby Bluhm wrote:
>
> It's been a while, I forget how to do this. I'd like the input/output on
> a 300LX to go through the serial line to a dumb terminal. Pointers are
> welcome.
>
Several suggestions came in:
At the SRM console: set console serial - 300LX SRM does not support the
"console" variable
Flip the "S3" switch on the back panel - 300LX does not have this switch
Set the motherboard jumpers located by the SCSI connector - Two jumper
sets exist there: W2 w/4 pins & W3 w/3 pins. I have not located the docs
on this yet.
This worked:
Unplug the monitor & keybd/mouse & connect a terminal to the 25 pin
serial port - Once I wired it up right, SRM console & boot up info
displayed on the terminal ( minicom on a Linux x86 actually .) After a
few moments to detect no kybd/mouse, was able to login at the terminal.
Thanks.
-tkb
Received on Wed Mar 28 2001 - 14:38:33 NZST