I have a following error message "can't open osf_boot" , searched the
archive and based on it tried to perform the following:
- boot from CD
- start the Unix shell
- verify the root partition with fsck (pray that the disk is still ok)
- if the partition is fine, try to copy osf_boot file from CD
However, I did not get very far with the above tasks, The CD boot fine, GUI
came up, click on UNIX Shell and nothing happened although the session is
still active (still can use the help and others), I can't get into UNIX
Shell.
Any suggestions on how to proceed ? Thanks in advanced.
Regards,
Nic
****************************************
(boot dra0.0.0.6.0 -flag A)
block 0 of dra0.0.0.6.0 is a valid Boot block
reading 32 blocks from dra0.0.0.6.0
bootstrap code read in
base=200000, image_start=0, image_bytes=4000
initializing HWRPB at 2000
initializing page table at 17ff0000
initializing machine state
setting affinity to the primary CPU
jumping to bootstrap code
can't open osf_boot
halted CPU0
haltcode=5
HALT instruction executed
PC=20000030
boot failure
P00>>>
****************************************
Received on Fri Apr 20 2001 - 06:35:44 NZST