SUMMARY: HSG80 configuration

From: Sloane, Robert Raymond <sloane_at_ukans.edu>
Date: Wed, 24 Oct 2001 13:49:26 -0500

Hi,

The consensus seemed to be that saving the configuration wasn't needed
when you have redundant controllers, since the configuration is stored
on both controllers. I guess you just have to type the configuration
in again if you have some sort of disaster that requires replacing
both controllers. The documentation for CONFIG SAVE specifically states:

"This command is appropriate only for a single-controller sub-system."

Thanks to all who replied.

-- 
Bob Sloane, University of Kansas Computer Center, Lawrence, KS, 66045
sloane_at_ukans.edu http://www.ukans.edu/home/sloane Phone:(785)864-0444
>We are converting our single controller HSG80 to dual controllers,
>and in reading through the documentation, I noticed that the command
>CONFIG SAVE cannot be used in a dual redundant configuration.  What
>happens if we need to rebuild this system from scratch? Do we have
>to write down the config on paper and type it all in again?  What
>disaster recovery of the configuration is available with dual
>controllers?

Received on Wed Oct 24 2001 - 18:50:30 NZDT