Original request below. The jumper from the fast-wide storage shelf did
work on the ultra-wide shelf. I received one reply from Carl Yeaman:
>>>
Blake, typically, DEC's/Compaq's configuration, for the model# is - the last
byte, after the last-dash, indicates the city / manufacturing-plant where
the device was made. I, certainly will not say that it'll work, but I
probably would try it. However, I do not even know what the ...356... is -
without looking it up. Good luck. [Carl] <<<
Original post:
Can you use a BA-35X-MC jumper from a BA356-RA in a BA356-RD? I'm waiting
for delivery on the correct jumper BA-35X-MF. I'm gonna try it anyway,
...but do you happen to know if the 16 bit jumpers are the same?
Best Regards,
Blake Brehl
Anritsu Company United States
Morgan Hill, CA 95037
blake.brehl_at_anritsu.com
This message is intended for the use of the individual/entity to whom it is addressed. This message may contain privileged information exempt from disclosure. If you are not the addressee, distribution or copying of this message, or dissemination of the information contained herein is strictly prohibited. If you should receive this message in error, please destroy it, or return to sender, Thank You
Received on Fri Jan 11 2002 - 03:09:20 NZDT