Managers,
4100 (4.0D)
We recently had a hardware failure of our tlz tape drive and I
replaced it with an Compaq SDT-10000. I set the scsi id correctly and
installed the drive. I confirmed that it was detected in the firmware. I
booted the computer and removed the old device files, rmt0* and nrmt0*.
The output of sc scan edt is as follows.
Device: RRD46 Bus: 0, Target: 5, Lun: 0, Type: Read-Only Direct
Access
Device: RZ1CB-CA Bus: 1, Target: 0, Lun: 0, Type: Direct Access
Device: BB00911CA0 Bus: 1, Target: 1, Lun: 0, Type: Direct Access
Device: RZ1CB-CS Bus: 1, Target: 2, Lun: 0, Type: Direct Access
Device: BB00911CA0 Bus: 1, Target: 3, Lun: 0, Type: Direct Access
Device: RZ29B Bus: 1, Target: 4, Lun: 0, Type: Direct Access
Device: RZ29B Bus: 1, Target: 5, Lun: 0, Type: Direct Access
Device: SDT-10000 Bus: 1, Target: 15, Lun: 0, Type: Sequential Acce
How do I create the device files for this drive?
Aaron Siebert
IT Engineer Nagrastar
Aaron.Siebert_at_nagrastar.com
Work: 303-706-5492
Fax: 303-706-5719
Received on Fri Jan 18 2002 - 16:29:06 NZDT