All...
Have searched the archives but cant see anything similar to the problem I
have.
I am setting up (another) brand new DS20E system. h/w vendor has delivered
kit and supposedly verified it runs h/w diags etc ok. I wasn't present when
this happened. Needless to say - they are now off site.
There is no o/s on this box. I am going to clone it from another DS20E we
have.
I could get no response from the console so power-cycled the box. I get the
following displayed:
16:14:14 *** keyboard not plugged in...
16:14:15 2048 Meg of system memory
16:14:15 probing hose 1, PCI
16:14:15 probing PCI-to-PCI bridge, bus 2
16:14:15 bus 0, slot 7 -- pka -- NCR 53C895
16:14:15 bus 2, slot 4 -- eia -- DE602-AA
16:14:15 bus 2, slot 5 -- eib -- DE602-AA
16:14:15 probing hose 0, PCI
16:14:15 probing PCI-to-ISA bridge, bus 1
16:14:16 bus 0, slot 5, function 1 -- dqa -- Cypress 82C693 IDE
16:14:16 bus 0, slot 5, function 2 -- dqb -- Cypress 82C693 IDE
16:14:16 bus 0, slot 6, function 0 -- pkb -- Adaptec AIC-7895
16:14:16 bus 0, slot 6, function 1 -- pkc -- Adaptec AIC-7895
16:14:16 bus 0, slot 7 -- pga -- KGPSA-C
16:14:16 bus 0, slot 8 -- pgb -- KGPSA-C
16:14:16 bus 0, slot 9 -- pkd -- QLogic ISP10x0
16:14:19 initializing GCT/FRU at 1ca000
But then the system just hangs. 10 minutes later and its still the same.
If I power cycle it again, I get the same response - or lack of it.
I was expecting to see the console prompt (>>>) displayed pretty soon after
the
"initializing GCT/FRU at 1ca000" line.
Has anybody seen this before? Any ideas would be appreciated.
regards - Tony
Received on Wed Feb 20 2002 - 17:03:18 NZDT