Hi!
This may a bit of topic but there are probably a couple of people that have
the same thoughts.
I have set up a couple of Tru64 v5.1A clusters and every time I wonder what
the correct way of setting up Legato Network client is.
Should I set up the client as a cluster service so there is only one node in
the cluster that runs the client and access the client through the cluster
alias (or an alias of it's own?)?
I am doing that on one cluster and it works fine.
Or...
Should the client run on all cluster nodes and you backup the cluster alias.
I am doing that too on one of clusters and it works fine.
What's supported and/or what's the best solution?
Comments anyone?
Regards Klas Erlandsson
Received on Thu Jun 06 2002 - 06:47:37 NZST