my question was...
Hello
I have no resolv a problem of communication on my network
I have send a email last week on this subject
I have a simple question:
I don't find the good syntaxe to have the ethernet card in half duplex mode?
at the boot time
set ewa0_mode fastfd for full duplex mode
but I don't know for half duplex mode in 100 Mb...
solutions...
1 - set ewa0_mode fast
2 - I think it is just fast, not fastfd.
You may also have to change the entry in /etc/rc.config and set the entry
after speed to 100, not 200, i.e.:
IFCONFIG_0="youripaddress netmask 255.255.255.0 speed 100"
3 - It seems to me that if, in console mode, you issue set ewa0_mode xyz, it
displays the possible syntaxes.
super!!!
thank you very much to: Smith Lawrie, Ken Kleiner, Daniel Clar
Josiane
---------------------------------------------------------------------
Josiane Tack
ISTEEM - CC 056
Universite Montpellier II
Place Eugene Bataillon
34095 MONTPELLIER Cedex 05
E-Mail: Josiane.Tack_at_dstu.univ-montp2.fr
--------------------------------------------------------------------
Received on Thu Aug 29 2002 - 14:31:22 NZST