thanks for the reply from Selden E Ball Jr <SEB_at_LNS62.LNS.CORNELL.EDU>
I used rcmgr to change from fta0 to alt0 and did a reboot. During system
startup, I saw on the console,
vmunix: alt0: 1000 Mbps full duplex Link Up via autonegotiation
The network is working.
I wonder if there is a command that will print this info (along the lines of
mii-tool in linux)
SS
----- Original Message -----
From: "Sridhar" <ssridhar_at_raven.pnu.com>
To: <tru64-unix-managers_at_ornl.gov>
Sent: Monday, October 28, 2002 11:23 AM
Subject: changing from fta0 to alt0 - additional flags
> I wanted to switch the networking from fta0 to alt0. Both cards are
> installed and in kernel. Hence I opened SYSMAN, chose configure network
> interface and chose alt0. Under "Additional Flags" I see 10MBPS half/full
> duplex, 100MB half/full duplex but no other choice (like 1000MBPS). The
> 10MBPS half duplex is the default choice. What should I pick here for
alt0?
>
> thanks
> SS
>
Received on Tue Oct 29 2002 - 14:54:41 NZDT