Hi All,
I have a problem with my KZPCC controller. About 2 weeks ago I had to have
the whole unit replaced, which went fine, but since then I have noticed that
the battery state is being reported as "bad" when looking through
StorageWorks Command Console (v2.2.0.213). This was after it went through
the initial calibration phase. I reported this to Compaq (HP) who sent an
engineer and he replaced the battery. Again after the initial period of
trying to calibrate the battery it is being reported as being "bad" again.
Now I can't really believe that 2 batteries, the new one when the card was
replaced and the new one from the engineer, can both be "bad". Other
details of the card are
Firmware revision: CQ16
Hardware revision: KZPCC-CE rev.D01
Bios Revision: 1.2H
Is there a command I have missed which effectively resets the state of the
battery as it might not have recognised that it has been replaced, or is
this a known problem, has anyone else come across this before or got any
suggestions?
Thanks in advance,
Steve Copper
_________________________________________________________________
This email and any files transmitted with it are confidential and
intended solely for the use of the individual or entity to whom
they are addressed. If you have received this email in error
please notify postmaster_at_westernpower.co.uk.
This footnote also confirms that this message has been swept
for all known viruses by the MessageLabs Virus Scanning Service.
For further information please visit
http://www.messagelabs.com
Received on Mon Dec 09 2002 - 15:13:45 NZDT