the answer is:
boot genvmunix to get the drivers load, then doconfig/reboot dance...
I have the cards now seen by the OS...
on the the EMC side and set up some LUNs....
thanks for all the help,
Jeff
----- Original Message -----
From: "Jeff Foster" <jfoster_at_uclink.berkeley.edu>
To: "tru64" <tru64-unix-managers_at_ornl.gov>
Sent: Tuesday, January 07, 2003 12:19 PM
Subject: FC adapter, driver not loading
> hi all,
>
> I have two KGPSA pci fc adapter which I plan to
> install into an ES-40 running 5.1a . I am testing getting them working on
> our EMC SANS (FC4700) with a test DS-20 (5.1a).
>
> I have them installed in the DS-20, the PROM sees them.
> When booting , I get the following error message
> Jan 7 12:01:10 ruby vmunix: Driver_support: Module emx failed to load.
> status:22
> Jan 7 12:01:10 ruby vmunix: Driver_support: Module emx failed to load.
> status:22
>
> looking on the web I see that a "config_drive emx" was
> suggested in sysconfigtab. tried this, did not work. I looked in
> sysconfigtab, uncommented the fc drive entry:
> emx:
> PCI_Option = PCI_SE_Rev - 0x210, Vendor_Id - 0x10df, Device_Id -
0x1ae5,
> Driver_Name - emx, Type - A, Adpt_Config - N
> PCI_Option = PCI_SE_Rev - 0x210, Vendor_Id - 0x10df, Device_Id -
0xf700,
> Driver_Name - emx, Type - A, Adpt_Config - N
> #
>
> did a doconfig/copy new kernel and reboot
>
> OS still can not load the module. any suggestion on getting these
> card configure would be great.
>
> thanks
> Jeff
> ----
> Jeff Foster 642-8552
> ccs-sda-unix UC Berkeley
>
>
Received on Tue Jan 07 2003 - 22:32:48 NZDT