Hi there -- is there a printcap option to pre-pend a file of escape codes to allow a job to print in landscape or whatever mode. We have just replaced all of our network printers and they like printing in portrait. At present I have to cat a file ( /var/spool/lp/landscapefile ) to front of the print job and pipe to lpd. Any better ideas? Thanks.
We are Tru64 5.1
#####################################################################################
This e-mail message has been scanned for Viruses and Content and cleared
by MailMarshal
#####################################################################################
****************************************************************************************************************************
CAUTION: This email and any attachments may contain information that is confidential. If you are not the intended recipient, you must not read, copy, distribute, disclose or use this email or any attachments. If you have received this email in error, please notify us and erase this email and any attachments. You must scan this email and any attachments for viruses.
DISCLAIMER: Powerco Limited accepts no liability for any loss, damage or other consequences, whether caused by its negligence or not, resulting directly or indirectly from the use of this email or attachments or for any changes made to this email and any attachments after sending by Powerco Limited. The opinions expressed in this email and any attachments are not necessarily those of Powerco Limited.
****************************************************************************************************************************
Received on Tue Jan 14 2003 - 02:22:06 NZDT