Hello managers...
I am sure my name is looking familiar by now from the DS20 episode (which was scrap).
I am trying to boot an ES40 with a KZPCC-CE 3 channel controller cards. It has 2 buses with 4-18.G drives on each. I have configured a RAID-5 with the four drives on bus 0 and left the others as HSP on bus 1. I have built the raid using SMOR. Everything looks fine within SMOR.
I downgraded the firmware to V6.0 after finding that suggestion on the web with someone who had similiar problems.
When I try to boot to a TRU64 v5.1a OS CD to do an install it hangs at
ata0 ACER M1543C
I had these problems yesterday and I moved the SCSI cables to different channel of the card and I go different results. I was able to boot to the CD but the OS did not complete and then the system hung at
scsi 0
At one point the operating system resumed configuring... as if it had been hung in memory.
Any suggestions on how to clear this ata0 error.
I thank you again.
Jane
Jane Caldwell-Myers
Laurentian University
705 675-1151 Ext. 2150
jane_at_laurentian.ca
Received on Tue Jun 10 2003 - 11:19:45 NZST