Thanks again to everyone that replied.
The overall response was to view the /var/adm/message file for the following
entry:
vmunix: rm slave: mchan0, hubslot = 1, phys_rail 0 (size 512 MB)
This worked once I was attached to the hub, but before I attached nothing
like this was in the message file. I had to open the box and look at the
jumpers. So this help me determine what the other machines were set to and
then I had to set the cards on the new machine to match.
Thanks again.
Original question:
Is there a way to view the settings on the MC cards without shutting down
and pulling the cards? I would like to determine if the memory jumper is set
to 128 or 512.
Howard Arnold
Consultant Engineer
Email: arnoldh_at_celerent.com
Phone: (603)685-6060 ext 206
Received on Mon Jul 14 2003 - 13:01:48 NZST