Thanks to all who replied, and gave many good suggestions. I'd like to
thank Shawn Cromer for his suggestion on changing the card's speed
configuration. Changing the card to 10-base half I was able to ping the
outside. I'll have to get in touch with our telecom depart to see if
they can bring that port up to 100-full.
Thanks again for all who contributed.
regards,
---Andy
Shawn's response was as follows:
You can hard set the speed at the PO>>> prompt
PO>>> set ewa0_mode fastfd
The above will set at 100 Full Duplex
fast will be 100 half and twisted will make it 10 half
---Originally Question Below---
> Hi All,
>
> I am running Tru64 UNIX 5.0A and can't seem to get the network card
> working. The card is a DEC TULIP (10/100) Ethernet Interface. I have
> gone through the various network settings over and over and everything
> is configured correctly. I've also tested the network port to make sure
> it wasn't to blame. I also noticed that doing a netstat -r will hang
> for about 5 minutes before returning any values.
>
> /var/adm/messages does show the network interface, so at this point I
> know the card is being detected and I assume at this point it to be
> working.
>
> Does anyone have any suggestions as to what else I can try?
>
>
> Thanks for any suggestions.
>
>
> ---Andy
>
>
Received on Mon Jul 21 2003 - 19:44:05 NZST