Hello Admin wizards,
update to the below described problem:
Obviously the device actually producing the alarm is the EMU of the DEC
Raid shelf.
Unfortunately I have no doc on this, and the 700 pages HSZ40 manual does
not cover it ... ideas?
not strictly Tru64, but ....
last week, one of the disks in a DEC raidshelf of ours went off. The
controller (HSZ 40) did what it is supposed to do, and all I had to do
the other day was to notice that the disk was to be replaced -
everything worked perfectly.
I replaced the disk, added a new spare and everything - but still the
alarm sound of the raidshelf is set to on and the amber LEDS are lit.
I have switched both of the power supplies off and on again, but they
seem to get a failure information from elsewhere - any idea where I can
reset the alarm?
thank you for any hint
CW
--
YS, CW
-----------------------------
Christian Wessely
http://www-theol.uni-graz.at
Received on Fri Oct 03 2003 - 13:41:44 NZST