Thanks to everyones responses so far. I will
summarize them soon. Here is really where I am stuck
now. I loaded Tru64 on the MSA, but I had to pull one
controller to do it. I also can only boot if one
controller is in. If both are in, they toggle back
and forth between being active and passive. Neither
one stays in an active state for more than a few
seconds.
--- Rich Glazier <rglazier2002_at_yahoo.com> wrote:
> Has anyone had any success getting an MSA1000 up in
> a
> Tru64 Unix envionment? I have upgaded everything to
> be within the martix. I can scan the fabric at an
> SRM
> level and see both paths, and can quickset luns
> successfully. I can also see all my luns (both
> paths)
> at the OS level, but can't touch them. If I try to
> disklabel the device I get an I/O error.
>
> -MSA1000
> -2 controllers _at_ firmware 4.24
> -2 7 port switches
> -2 KGPSAs (FCA2354)
> -DS20E _at_ firmware 6.6
> -Tru64 Unix 5.1A PatchKit 6
>
> __________________________________
> Do you Yahoo!?
> Yahoo! Hotjobs: Enter the "Signing Bonus"
> Sweepstakes
> http://hotjobs.sweepstakes.yahoo.com/signingbonus
__________________________________
Do you Yahoo!?
Yahoo! Hotjobs: Enter the "Signing Bonus" Sweepstakes
http://hotjobs.sweepstakes.yahoo.com/signingbonus
Received on Wed Jan 14 2004 - 19:11:52 NZDT