SUMMARY: UNknown Error in Reboot

From: Ricardo \(Tru64 User\) <"Ricardo>
Date: Fri, 16 Jan 2004 13:39:49 -0800 (PST)

I feel stupid....
thnx to all who replied.
I thought bcheckrc will always do the mount /, but
apparently not always (it always do that on my 4100's
at least so far)
so i had to go thru the mount -u /, which gave me a
chance to edit fstab.
All FS's were ufs...is that the reason why it would
not boot at all? I expected it to yell about problem
disk, and continue without mounting it.

I have isolated the dead disk.....and came back up.

_Thanks

If the disk was getting I/O errors before the problem
        and has disappeared after the reboot, the odds are
        pretty good that it failed.

        With the operating system shutdown, use the console
        to see what devices are seen by the console "SHOW
        DEVICE" command. If the drive in question isn't
        one of them, then whatever is wrong is enough to
        prevent simple, common, SCSI commands from working.

        Check the connectivity of the device back to the
        host, since it could be cabling. If the console
        still can't see the drive, contact your service
        vendor to get the drive replaced.

        If the console can see it boot the host to single
user.

        Run bcheckrc to verify the other file systems are
        ok. That will also probably leave the root mounted.
        If not, mount it with "mount -u /". Then edit
        /etc/fstab to prevent future reboots from trying
        to check the device (at least until repaired).

        Then you can boot to multiuser if there are others
        using the system that don't depend on the drive.

        Whether single user or multiple user, use scu(8) to
        see if the drive will offer a clue what is wrong.
        If the operating system didn't see it, you'll need
        to set the address explicitly. The special file
        name of rz31 suggests that the disk is on bus 3,
        target 7, LUN 0. Use "set nexus" to identify the
        address. Then try some simple SCSI commands:

                show device - Inquiry
                show capacity - Read Capacity
                tur - Test Unit Ready

        If these fail, they may offer a clue what is wrong.



__________________________________
Do you Yahoo!?
Yahoo! Hotjobs: Enter the "Signing Bonus" Sweepstakes
http://hotjobs.sweepstakes.yahoo.com/signingbonus
Received on Fri Jan 16 2004 - 21:43:06 NZDT

This archive was generated by hypermail 2.4.0 : Wed Nov 08 2023 - 11:53:44 NZDT