I wrote:
Hi Managers!
I got a used BA370 enclosure with 2 HSG80 controllers.
During transportation a fan was broken which I replaced.
All the fans are running now, the wind stream can be felt.
After the command
configuration reset
the error
Fan failure detected.
still exists.
Can somebody point me to the command to reset this error?
Thank you very much for your help!
(The ACS Version 87F-1 is installed)
Thany you very much for all who replied.
The hint was
clear cli
I think I was too unclear in my request.
The error message disappears then,
but the error remains.
I.E., after rebbot of HSG80's this error is there again, AND,
more important,
after some minutes the HSG80 shutds the power off,
I think due to a security loop not to overheat the controller.
Any ideas?
--
Mit freundlichen Gruessen / With best regards
Reiner Dassing
Received on Mon Sep 13 2004 - 10:01:49 NZST