Hi,
I have a HSG80 with a single controller with 512MB cache direct attached
(without a switch/hub) to a DS20E (dual 666MHz).
When initialising a raidset on the HSG80 with 6 disks (72GB 15K RPM)
over 6 ports/channels I don't get more than 4200KB/s read and 820KB/s
write throughput per port (vtdpy, display device).
Also when accessing a diskset like this I have never been able to read
or write more than 20~30MB/S.
Shouldn't this controller be capable of more than this, with these
disks?
OS: Tru64 UNIX 5.1B PK3
FC: KGPSA-CA : Driver Rev 2.10 : F/W Rev _3.91A1(2.20A0)
emx0: Using console topology setting _of : Loop
HSG80: Software V87G-4, Hardware E12
PORT_1_TOPOLOGY = LOOP_HARD (loop up)
Regards,
Maurice Akkermans
Sys.Adm.
Tellabs Denmark A/S
maurice.akkermans_at_tellabs.com
-----------------------------------------
============================================================ The
information contained in this message may be privileged and confidential
and protected from disclosure. If the reader of this message is not the
intended recipient, or an employee or agent responsible for delivering
this message to the intended recipient, you are hereby notified that any
reproduction, dissemination or distribution of this communication is
strictly prohibited. If you have received this communication in error,
please notify us immediately by replying to the message and deleting it
from your computer. Thank you. Tellabs
============================================================
Received on Fri Nov 26 2004 - 12:44:01 NZDT