Hello All,
Thanks to Ian Barker for his response. And to Christian and Russ at HP
support who helped during the actual process.
The bottomline solution was to follow the instructions in the New Hardware
Delivery 3 - Release Notes and Installation Instructions -- Section 3.4,
skipping steps 1-8 which relate to shutting the system down before a new
full installation.
Basically the NHD3 CD is booted first with the following command:
boot -fl fax -fi GENERIC dqa0
Then follow the directions, swapping in the OS installation CD when prompted.
Pay particular attention to step 18 which specifies interrupting the reboot
after the OS loads the subsets. You must reboot from the NHD CD and not
allow the system to boot to the hard disk.
Also, there is a misleading blurb in the notes about the NHD3 CD not being
bootable on IDE CDROMs. I misinterpreted this statement. It relates only to
the procedure for creating a CD in section 2.1 of the release notes and
not to an actual NHD3 CD.
John
Original Question:
-----------------------------------------------------------------------------
Hello Managers,
I've seen some questions and answers in the list archives concerning this,
but nothing definitive.
I have a client who, due to applications limitations, must run T64 version
4.0f on an ES40.
The hardware consists of the ES40, a KCPCC-CE internal raid controller, and
two KGPSA HBAs ( for connectivity to a dedicated SAN consisting of two
HSG80 controllers).
The client wants to use a mirrorset on the KZPCC as the boot device.
However, that controller is not nativity supported by 4.0f, so I need NHD3
to get that support.
Is there are way to load the OS directly on a unit on the KZPCC and load
the NHD3 at the same time? If so, can someone detail the procedure for me.
If not, ( and I suspect not) I assume I can load the OS on a standalone
internal SCSI disk and then load the NHD3. I can then use a vdump/vrestore
procedure to move the root/usr/var domains to a unit on the KZPCC.
Correct? ( I have moved the filesystems and made the new disk bootable
before, so I don't need detailed instructions, just a confirmation that it
can be done in this case.)
If I use the standalone method, do I load the OS, then patch kit 8, then
the NHD in that order? And should the KZPCC be physically installed in the
ES40 while I am loading the OS and patches?
Any other gotchas, or recommendations would be welcome.
Thanks.
John
Received on Thu May 26 2005 - 13:43:27 NZST